Oly Flash Setup

Here's a quick description of how I made a flash cable to go between by Uzi and my Sunpak 544
 

Since I had to cut an end off anyway I bought the CB01 which has the standard Oly connector on each end.  Shown above is my completed cable and the spare half.

Here's the pin-out of the Oly cable.  The sync needs to connect to the sync wire from the flash.  Either the chassis ground or the signal ground can be used as the common.

Here's the end of the flash cable.  In my case the sync was white but color may vary.  The sync will always be the insulated wire and ground will always be a bare shield.

Pic of the Sunpak 544 and my F3 for size reference

Another angle showing off tilt and swivel.